DTC B178C: Vehicle Factory Calibration Uncompleted

Diagnosis start condition: 

When the ignition voltage is 10 - 16 V.

DTC detecting condition: 

• [Rezeroing] for the occupant detection system was not performed at vehicle factory.
• [Rezeroing] was not performed after replacing the airbag control module.
• [Rezeroing] was not performed after replacing the passenger's seat assembly.

Trouble symptom: 

Occupant judgment of airbag control module stops.

1. PERFORM [Rezeroing]  .
   1. Perform [Rezeroing]. Ref. to AIRBAG (DIAGNOSTICS)>REZERO 
   2. Using the Subaru Select Monitor, perform the clear memory of [Airbag]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY
   3. Execute the inspection mode. Ref. to AIRBAG (DIAGNOSTICS)>INSPECTION MODE 
   4. Read the DTC of [Airbag] using the Subaru Select Monitor. Ref. to AIRBAG (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) 

   Is DTC B178C displayed? (Current code)

   Yes  : Replace the airbag control module. Ref. to AIRBAG SYSTEM>AIRBAG CONTROL MODULE>REMOVAL

   No  : [Rezeroing] was not performed.