Execution Condition
WARNING: This page is about a different variant/trim than selected.
| Secondary parameters | Execution condition |
|---|---|
| Diagnosis 1 12 V battery system voltage Transmission range Measured secondary pulley shaft speed Measured front output shaft speed Commanded forward & reverse clutch pressure control solenoid current Engine speed |
10 V or more Drive 100 rpm or more 100 rpm or more Less than 0.9 A 400 rpm or more |
| Diagnosis 2 12 V battery system voltage Transmission range Measured front output shaft speed Commanded forward & reverse clutch pressure control solenoid current Accelerator pedal position (from ECM) Engine speed |
10 V or more Drive Less than 100 rpm Less than 0.9 A Exceeds 6% 400 rpm or more |