Diagnostic Method
WARNING: This page is about a different variant/trim than selected.
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
JUDGMENT VALUE SPECIFICATION
| Malfunction Criteria | Threshold Value | ||
|---|---|---|---|
| Diagnosis 1 ABS(1) (Measured front output shaft speed - Measured secondary pulley shaft speed) |
Exceeds rpm values in Table 1 |
||
| Diagnosis 2 Measured secondary pulley shaft speed |
More than 600 rpm |
||
|
|||
ABS: ABSOLUTE VALUE, VEHICLE SPEED SPECIFICATION
| Vehicle speed (calculated from front output shaft speed sensor) (MPH) | 0 | 13 | 25 | 38 | 50 | 63 | 75 |
| ABS (Measured front output shaft speed - Measured secondary pulley shaft speed) (rpm) | 150 | 100 | 100 | 100 | 100 | 100 | 100 |
| Vehicle speed (calculated from front output shaft speed sensor) (MPH) | 88 | 100 | 113 | 125 | 138 | 150 | 159 |
| ABS (Measured front output shaft speed - Measured secondary pulley shaft speed) (rpm) | 100 | 100 | 100 | 100 | 100 | 100 | 100 |
Time needed for diagnosis: 5 s
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.