Diagnostic Method
WARNING: This page is about a different variant/trim than selected.
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
JUDGMENT VALUE SPECIFICATION
| Malfunction Criteria | Threshold Value | ||
|---|---|---|---|
| Phase 1 ABS(1) (Target line pressure - Measured line pressure) Measured line pressure |
More than 500 kPa Less than 3000 kPa |
||
| Phase 2 Measured line pressure sensor input voltage (Line pressure) Measured line pressure sensor input voltage (Line pressure)
NOTE:
Both Phase 1 and Phase 2 must be met to fail the diagnostics. |
0.8 V or less (570 kPa or less) 0.195 V or more (0 kPa or more) |
||
|
|||
Time needed for diagnosis:
- Phase 1 : 5 s
- Phase 2 : 3 s
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.