Transmission Rear CROSSMEMBER And Rear Cushion Rubber

WARNING: This page is about a different variant/trim than selected.

Install the rear cushion rubber.
Tightening torque:

40 N.m (4.1 kgf-m, 29.5 ft-lb)
Install the transmission rear crossmember.
Tightening torque:

T1: 35 N.m (3.6 kgf-m, 25.8 ft-lb)

T2: 70 N.m (7.1 kgf-m, 51.6 ft-lb)

Fig 1: Transmission Rear Crossmember, Nuts And Bolts With Torque Specification
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Install the center exhaust cover. Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION
Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR)