LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (CVT Transaxle (Tr690)) >> Rear Wheel Speed Sensor >> Installation

Rear Wheel Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:

If water or oil contacts the connector terminal of rear wheel speed sensor, replace it with a new part. 

  1. Install the rear wheel speed sensor using a new O-ring, and connect the connector.
    NOTE:

    Apply CVTF to the O-rings. 

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  2. Install the center exhaust cover. Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION
  3. Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR)
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
scientia non olet · About LEMON Manuals