DTC B1507: Outside Temperature Sensor Open Detected

DTC detecting condition: 

Open or short circuit in ambient sensor

Trouble symptom: 

• Defective ambient temperature display
• Defective air conditioner operation

Wiring diagram: 

Combination meter system Ref. to WIRING SYSTEM>COMBINATION METER SYSTEM>WIRING DIAGRAM

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK DTC  .
   1. Turn the ignition switch to ON.
   2. Read the DTC of [Combination Meter] using the Subaru Select Monitor. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) 

   Is DTC B1507 displayed? (Current code)

   Yes  : Go to  2.

   No  : Go to  6.

2. CHECK DATA MONITOR  .

   Using the Subaru Select Monitor, read data of [Ambient air temperature] in the [Data Monitor] of [Combination Meter]. Ref. to COMBINATION METER (DIAGNOSTICS)>DATA MONITOR 

   Is [Ambient air temperature] displayed?

   Yes  : Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE:

   In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause. 

   No  : Go to  3.

3. CHECK HARNESS (OPEN CIRCUIT)  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from the combination meter.
   3. Disconnect the connector from ambient sensor.
   4. Using a tester, measure the resistance between the combination meter connector and ambient sensor connector.

      Connector & terminal 

      (i97) No. 23 - (B104) No. 2:

      (i97) No. 24 - (B104) No. 1:

   Is the resistance 10 Ω or less?

   Yes  : Go to  4.

   No  : Repair the open circuit of harness or replace harness.

4. CHECK HARNESS (GROUND SHORT CIRCUIT)  .

   Use a tester to measure the resistance between the combination meter connector and chassis ground.

   Connector & terminal 

   (i97) No. 23 - Chassis ground:

   (i97) No. 24 - Chassis ground:

   Is the resistance 10 Ω or less?

   Yes  : Repair the short circuit of harness or replace harness.

   No  : Go to  5.

5. CHECK AMBIENT SENSOR  .

   Perform the inspection of ambient sensor unit. Ref. to AIR CONDITIONER>AMBIENT SENSOR>INSPECTION

   Is the check result OK?

   Yes  : Go to  6.

   No  : Replace the sensor. Ref. to AIR CONDITIONER>AMBIENT SENSOR

6. CHECK CONNECTOR  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from the combination meter.
   3. Disconnect the connector from ambient sensor.
   4. Check connectors for poor connections.

   Is there poor contact of connector?

   Yes  : Repair or replace the poor contact of connector.

   No  : Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE:

   In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.