Propeller Shaft: Installation
- Apply transmission gear oil to the oil seal lip and propeller shaft sleeve yoke. (MT model)
- Apply CVTF to the oil seal lip and propeller shaft sleeve yoke. (CVT model)
- Insert the sleeve yoke into the transmission and attach center bearing bolt.CAUTION:
Do not bend the joint of the propeller shaft more than required.
Tightening torque:
52 N.m (5.3 kgf-m, 38.4 ft-lb)
Align the alignment marks (A), and connect the propeller shaft and rear differential.
Tightening torque:
31 N.m (3.2 kgf-m, 22.9 ft-lb)
- Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR) .
- Install the center exhaust cover and rear exhaust pipe. Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION .
- Release the shift lock and shift the select lever to the "P range". (CVT model) Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .
- Apply the parking brake.
- Check the level of the transmission gear oil. (MT model) Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (TY75)>TRANSMISSION GEAR OIL>INSPECTION .
- Check the CVTF level. (CVT model) Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>CVTF>INSPECTION .