EBD Warning Light, Abs Warning, VDC Off Indicator Light, VDC Warning Light And VDC Indicator Light Do Not Come On

Detecting condition: 

Defective combination meter

Trouble symptom: 

When the ignition switch is turned to ON (engine OFF), brake warning light (EBD warning light), ABS warning light, VDC OFF indicator light, and VDC warning light & VDC indicator light do not illuminate.

1. CHECK OTHER INDICATOR LIGHT  .

   Turn the ignition switch to ON.

   Immediately after the ignition switch is turned to ON, do all the indicator lights for VDC system and others illuminate?

   Yes  : Go to  2.

   No  : Check the combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>ACTIVE TEST

2. CHECK VDC CONTROL MODULE  .

   Using the Subaru Select Monitor, read data of [EBD Warning Light] in the [Data Monitor] of [Brake Control] while the engine is not running. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DATA MONITOR 

   Immediately after the ignition switch is turned to ON, is the [EBD Warning Light] set to [ON]?

   Yes  : Go to  3.

   No  : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)

3. CHECK VDC CONTROL MODULE  .

   Using the Subaru Select Monitor, read data of [ABS Warning Lamp] in the [Data Monitor] of [Brake Control] while the engine is not running. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DATA MONITOR 

   Immediately after the ignition switch is turned to ON, is the [ABS Warning Lamp] set to [ON]?

   Yes  : Go to  4.

   No  : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)

4. CHECK VDC CONTROL MODULE  .

   Using the Subaru Select Monitor, read data of [VDC-OFF Light] in the [Data Monitor] of [Brake Control] while the engine is not running. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DATA MONITOR 

   Immediately after the ignition switch is turned to ON, is the [VDC-OFF Light] set to [ON]?

   Yes  : Go to  5.

   No  : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)

5. CHECK VDC CONTROL MODULE  .

   Using the Subaru Select Monitor, read data of [VDC Warning Lamp] in the [Data Monitor] of [Brake Control] while the engine is not running. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DATA MONITOR 

   Immediately after the ignition switch is turned to ON, is the [VDC Warning Lamp] set to [ON]?

   Yes  : Check the combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE

   No  : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)