DTC C1412: Selected Parameter

DTC detecting condition:

A fault is detected if abnormal set value is found on the vehicle model that were given some parameters.

Trouble symptom:

ABS does not operate.
VDC does not operate.
AVH does not function.
EyeSight does not operate.

NOTE:

When the VDC Control Module & H/U is replaced, this DTC may be stored.

CHECK VDC Control Module & H/U IDENTIFICATION SYMBOL .
Check the identification symbol attached on the H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>GENERAL DESCRIPTION>SPECIFICATION

Is the identification symbol correct?

Yes : Go to 2.

No : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)
CHECK PARAMETER SELECTED IN VDC Control Module .
Check the VDC Control Module parameters. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)>MAINTENANCE MODE>VDC CONTROL MODULE PARAMETER CHECK

Does the parameter registered in the VDC Control Module match the relevant vehicle?

Yes : Go to 3.

No : Select and register the correct parameter. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)>MAINTENANCE MODE>VDC CONTROL MODULE PARAMETER SELECTION
CHECK SPECIFICATIONS OF OTHER CONTROL MODULES .
Check the specifications of ECM and TCM.

Are the specifications of ECM and TCM the same as vehicle specification?

Yes : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)

No : Replace the ECM and TCM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>ENGINE CONTROL MODULE (ECM) Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSMISSION CONTROL MODULE (TCM)