LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Front Bumper >> Removal >> Bumper Face

Bumper Face

  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  2. Remove the bolts and clips, and then remove the plate UPR front and sealing bumper front as a unit.
    G14612927Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the bumper face front.
    1. Remove the clip.
      G14612928Courtesy of SUBARU OF AMERICA, INC.
    2. While pushing up the lower side (a) of the bumper face front, release the engagement in the order from (b) to (f).
      CAUTION:

      Do not pull forcibly. It may damage the flange section on the bumper face front side when it comes off from the claws of the bumper bracket. 

      G14612929Courtesy of SUBARU OF AMERICA, INC.
    3. Disconnect the connector of the fog light assembly front.
      NOTE:

      Perform the same procedures on the opposite side. 

    4. Remove the bumper face front.
      NOTE:

      For convenience and safety, perform the work with 2 people. 

scientia non olet · About LEMON Manuals