LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> Rear Combination Light Assembly >> Installation

Rear Combination Light Assembly: Installation

  1. Connect the connector, and install the light assembly rear combination.
    CAUTION:
    • Be careful not to catch the harness in between the parts. 
    • Make sure that gaskets are attached on the combination light assembly. If a gasket is not attached, water leakage may occur. 

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  2. Install the cover assembly rear combination light.
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
scientia non olet · About LEMON Manuals