Multi Information Display Switch
- Measure the resistance between connector terminals.
Terminal No. Inspection conditions Standard 3 - 2 (UP)
i
(DOWN)All OFF Approx. 3 MΩ or more (UP) ON Less than 1 Ω i ON Approx. 1, 000 Ω (DOWN) ON Approx. 3, 700 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.CAUTION:
When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.
Terminal No. Inspection conditions Specification 1 (+) - 4 (-) Apply battery voltage. Light ON - Replace the switch assembly steering (MID) if it is found defective.