Vehicle Information Registration

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. Register the vehicle information according to the procedure of "Selection of Parameter", and confirm the vehicle information content in "Confirm on parameter".
   • PARAMETER SELECTION
     NOTE:

     • To check the applied model, refer to the "Model number plate" attached to the vehicle. Ref. to  IDENTIFICATION 
     • If you entered a wrong applied model, re-enter. 
     1. Using the Subaru Select Monitor, select [Selection of Parameter] in [Work Support] of [EyeSight]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT
     2. Check the applied model and option code indicated on the "Model number plate". Ref. to IDENTIFICATION
     3. Enter the applied model (alphanumeric characters) and press the Enter key.
     4. When the option code input screen appears after entering the applied model, enter the option code (alphanumeric characters), and press the Enter key.
     5. When the confirmation screen indicating the vehicle information appears, check that the correct applied model and option code are displayed and click [OK].
        NOTE:

        When the displayed applied model and option code are different from those of the vehicle, click [OK] and then perform the registration operation again. 

        
        Note that checking the digit corresponding to option code is not required if "" or "_" is displayed for option code.
   • PARAMETER CHECK
     NOTE:

     The parameter data registered in the stereo camera is shown on the display. 

     1. Using the Subaru Select Monitor, select [Confirm on parameter] in [Work Support] of [EyeSight]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT
     2. On the [Confirm on parameter] screen, check that the applied model and option code for the relevant vehicle are displayed, and click [OK].
     3. If the applied model and option code for the relevant vehicle are not displayed on the [Confirm on parameter] screen, perform parameter selection and registration.
        NOTE:

        Note that checking the digit corresponding to option code is not required if "" or "_" is displayed for option code. 

2. Next, perform the adjustment value clear operation. Ref. to EYESIGHT>CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>ADJUSTMENT VALUE CLEAR