Except For Electric Brake Booster Model
CAUTION:
- Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.
- Prepare a container to catch grease or oil, etc. If any grease or oil spills, wipe it off and clean immediately to prevent from penetrating into floor or flowing outside.
- Before removing the master cylinder assembly, depress the brake pedal several times to make sure that the negative pressure in the vacuum booster assembly is completely removed.
- After the master cylinder assembly is removed, inspect the cylinder seal assembly and the sealing surface of the vacuum booster assembly.
- If the sealing surface of the vacuum booster assembly has a defect such as flaking paint, damage or rust, it may cause negative pressure leakage. Therefore, replace the vacuum booster assembly with a new part.
- Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Remove the engine control module (ECM). Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>ENGINE CONTROL MODULE (ECM)>REMOVAL .
- Drain brake fluid completely from the oil reservoir COMPL.
- Remove the master cylinder assembly.
- Remove the hose clamp and disconnect the reservoir hose assembly.
- Remove the harness clip (a) from the bracket harness, and disconnect the connector (b) of the level indicator.
- Separate pipe assembly front ABS using a flare nut wrench.
- Remove the nuts, and slowly remove the master cylinder assembly from the vacuum booster assembly.
- Remove the hose clamp and disconnect the reservoir hose assembly.