Rear Brake Hose

Route the brake hose rear through the hole of bracket, and lightly tighten the flare nut to connect pipe center brake rear.
Insert the clamp brake hose and secure the brake hose rear.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)
Install the brake hose rear to caliper body using a new gasket.
Tightening torque:

26 N.m (2.7 kgf-m, 19.2 ft-lb)
Install the pipe center brake rear.
CAUTION:
Be careful not to make scratches or other damage to the inside surface of the brake pipe flare.
1. Turn and tighten the flare nut (b) by hand while pushing the pipe center brake rear (a) away from yourself.
2. Tighten the flare nut (b) using a flare nut wrench and a crowfoot wrench.
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Calculation formula

T = 15 N.m (1.5 kgf-m, 11.1 ft-lb) x L1/(L1 + L2)

T: Reading of the torque wrench

L1: Effective length of the torque wrench

L2: Effective length of the crowfoot wrench

NOTE:
If the effective length of the tool used is unknown, consult the manufacturer of the tool.

Courtesy of SUBARU OF AMERICA, INC.
Bleed air from the brake system. Ref. to BRAKE>AIR BLEEDING>PROCEDURE .
Install the rear wheels. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>INSTALLATION .