LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Rear Shelf Trim >> Removal

Rear Shelf Trim: Removal

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to  AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION 
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed. 
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  2. Remove the rear seat cushion assembly and the backrest assembly. Ref. to SEATS>REAR SEAT>REMOVAL
  3. Remove the trim panel assembly C pillar LWR and the trim panel assembly C pillar. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>REMOVAL 
  4. Remove the belt assembly rear OUT CTR lower anchor. Ref. to SEAT BELT SYSTEM>REAR SEAT BELT>REMOVAL>BELT ASSEMBLY REAR OUT CTR
  5. Remove the trim panel assembly rear shelf.
    1. Disconnect the connector of the cord assembly high-mounted.
    2. Release the clips to float the trim panel assembly rear shelf.
    3. Remove the belt cover, and guide the anchor of the belt assembly rear OUT CTR to behind the trim panel assembly rear shelf.
    4. Remove the trim panel assembly rear shelf.
      G14613063Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals