LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seat System - Seats >> Seat Heater >> Installation >> Seat Heater Unit >> Front Seat

Front Seat

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to  AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION 

  1. Install the seat heater unit in a new seat pad assembly.
    CAUTION:

    If the seat heater unit is reused, remove the polyurethane section and double-sided tape from the reverse side completely. Use new double-sided tape. 

    Preparation items: 

    Double-sided tape: NITTO DENKO 501L or equivalent

  2. Install the front seat surface. Ref. to SEATS>FRONT SEAT>ASSEMBLY 
  3. Install the front seat. Ref. to SEATS>FRONT SEAT>INSTALLATION 
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  5. Regarding the front seat (passenger's seat), perform [Rezeroing] for the occupant detection system. Ref. to AIRBAG (DIAGNOSTICS)>REZERO
  6. Regarding the front seat (passenger's seat), perform "Occupant Detection System Inspection" to check if the occupant detection system operates normally. Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>SEAT
scientia non olet · About LEMON Manuals