Related Lines, More Than 52 Ω And Less Than 62 Ω ((G) Chassis Can_Airbag)

Wiring diagram: 

CAN communication system Ref. to WIRING SYSTEM>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the airbag control module connector.
   3. Using a tester, measure the resistance between terminals in airbag control module connector.
      CAUTION:

      To measure the voltage and resistance of airbag system component, be sure to use the specified test harness. Ref. to  AIRBAG (DIAGNOSTICS)>GENERAL DESCRIPTION>PREPARATION TOOL 

      Connector & terminal 

      (AB42) No. 45 - (AB42) No. 46:

   Is the resistance 400 Ω or more?

   Yes  : A related line between airbag control module and main wiring harness is open, or main wiring harness is open at two places or more.

   No  : Go to  2.

2. CHECK RELATED LINES  .
   1. Disconnect the central gateway control module connector.
   2. Using a tester, measure the resistance between airbag control module connector and central gateway control module connector.
      CAUTION:

      To measure the voltage and resistance of airbag system component, be sure to use the specified test harness. Ref. to  AIRBAG (DIAGNOSTICS)>GENERAL DESCRIPTION>PREPARATION TOOL 

      Connector & terminal 

      (AB42) No. 45 - (i88) No. 25:

      (AB42) No. 46 - (i88) No. 26:

   Is the resistance 10 Ω or more?

   Yes  : Repair or replace the open circuit of the airbag related lines.

   No  : Check DTC of the airbag. Ref. to AIRBAG (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)