Real-time Diagnosis: Operation

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [EyeSight], and then select [Enter].
On [Select Function] screen, select [Data monitor].

Check that the display changes and the contents are correct when performing the operations as follows. If they are not displayed properly, check the following items.

OPERATION	Item	Note
Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)	Brake Lamp SW Brake SW Input Brake Lamp SW (VDC)	-
Turn the cruise main switch to ON.	Cruise Control SW Voltage (Port19) Cruise Control SW Voltage (Port20)	-
Turn the "SET/-" switch to ON.	Cruise Control SW Voltage (Port19) Cruise Control SW Voltage (Port20)	-
Turn the "RES/+" switch to ON.	Cruise Control SW Voltage (Port19) Cruise Control SW Voltage (Port20)	-
Turn the "Lane keep" switch to ON.	Cruise Control SW Voltage (Port19) Cruise Control SW Voltage (Port20)	-
Operate the shift lever.	Shift Position	-
Open/close the front and rear doors.	Driver Door Status Passenger Door Front Status Right Rear Door Status Left Rear Door Status	-
Unbuckle and buckle the driver's seat belt.	Driver Seat Belt Status	-

NOTE:

For detailed operation procedures, refer to "Help" of application.
For the item [Cruise Control SW Voltage (Port19)], refer to terminal No. 19 of the control module I/O signal.
For the item [Cruise Control SW Voltage (Port20)], refer to terminal No. 20 of the control module I/O signal. Ref. to EYESIGHT (DIAGNOSTICS)>CONTROL MODULE I/O SIGNAL