SRH Warning Light Blinks
Initialization is required after replacing the auto headlight beam leveler control module. Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE
- CHECK DTC
.
Read the DTC of [Headlight/Foglight] using the Subaru Select Monitor. Ref. to HEADLIGHT/FOGLIGHT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)
Are any DTCs displayed? (Current code)
Yes : Perform the diagnosis for the displayed DTCs. Ref. to HEADLIGHT/FOGLIGHT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST
No : Go to 2.
- CHECK DTC
.
Read the DTC of [Combination Meter] using the Subaru Select Monitor. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)
Are any DTCs displayed? (Current code)
Yes : Perform the diagnosis for the displayed DTCs. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST
No : Go to 3.
- CHECK FOR POOR CONTACT
.
Check the auto headlight beam leveler control module and combination meter connectors for poor contact (half engagement, etc.)
Is the check result OK?
Yes : The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
No : Repair the poor contact of connector, and check that the problem is resolved. If the problem is resolved, it is possible that temporary poor contact occurred.