Auto Headlight Beam Leveler Warning Light Blinks (Not Initialized)
Initialization is required after replacing the auto headlight beam leveler control module. Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE
- INITIALIZE AUTO HEADLIGHT BEAM LEVELER CONTROL MODULE
.
Initialize the auto headlight beam leveler control module. Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE
Is the initialization completed successfully?
Yes : The auto headlight beam leveler control module was initialized.
No : Go to 2.
- CHECK DTC
.
Read the DTC of [Headlight/Foglight] using the Subaru Select Monitor. Ref. to HEADLIGHT/FOGLIGHT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)
Are any DTCs displayed? (Current code)
Yes : Perform the diagnosis for the displayed DTCs. Ref. to HEADLIGHT/FOGLIGHT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST
No : Go to 3.
- CHECK DTC
.
Read the DTC of [Combination Meter] using the Subaru Select Monitor. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)
Are any DTCs displayed? (Current code)
Yes : Perform the diagnosis for the displayed DTCs. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST
No : Go to 4.
- CHECK DTC
.
Read the DTC of [Body Control] using the Subaru Select Monitor. Ref. to BODY CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)
Are any DTCs displayed? (Current code)
Yes : Perform the diagnosis for the displayed DTCs. Ref. to BODY CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST
No : Go to 5.
- CHECK HEADLIGHT LO BEAM SIGNAL
.
Set the headlight switch to Lo beam to illuminate it.
Does the Lo beam come on?
Yes : Go to 6.
No : Check the headlight. Ref. to LIGHTING SYSTEM>HEADLIGHT SYSTEM>INSPECTION
- CHECK FOR POOR CONTACT
.
Check the auto headlight beam leveler control module, combination meter, body integrated unit, or headlight connector for poor contact (half engagement, etc.).
Is the check result OK?
Yes : The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
No : Repair the poor contact of connector, and check that the problem is resolved. If the problem is resolved, it is possible that temporary poor contact occurred.