Inspection Using Can Diagnostic
Trouble causes:
Improper body integrated unit setting
Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to LAN SYSTEM (DIAGNOSTICS)>General Description> CAUTION .
- CHECK BODY INTEGRATED UNIT REGISTRATION STATUS
.
Check that settings of body integrated unit correspond to vehicle equipment. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT .
Does the vehicle equipment correspond to settings?
Yes : Go to 2.
No : Match the settings of the body integrated unit with the vehicle equipment.
- CHECK BODY INTEGRATED UNIT CUSTOMIZE SETTING
.
Check that settings of body integrated unit correspond to vehicle condition. Ref. to BODY CONTROL (DIAGNOSTICS)>CUSTOMIZE .
Do the customize settings correspond to the vehicle condition?
Yes : Go to 3.
No : Match the settings of the body integrated unit with the vehicle condition.
- CHECK FACTORY INITIAL SETTING OF BODY INTEGRATED UNIT
.
Confirm [Factory initial setting] of body integrated unit registrations is [Market]. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT .
Is it set to [Market]?
Yes : Go to step 4 in the Basic Diagnostic Procedure. Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure>PROCEDURE .
No : Switch from [Factory] to [Market].