LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> Ascent Touring >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System (Diagnostics) >> Diagnostics with Phenomenon >> Inspection >> High Beam Assist Indicator Does Not Illuminate

High Beam Assist Indicator Does Not Illuminate

Trouble symptom: 

High beam assist indicator light does not illuminate though the operating conditions for the high beam assist are met.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to BODY CONTROL (DIAGNOSTICS)>General Description>CAUTION .
NOTE: If the combination switch, combination meter, auto light sensor, or auto lighting operation is defective, diagnose each system first.
  1. CHECK BODY INTEGRATED UNIT SETTING  .

    Using the Subaru Select Monitor, check the following items in the [Data monitor] of [Body Control]. Ref. to BODY CONTROL (DIAGNOSTICS)>DATA MONITOR .

    • High Beam Assist Function Setting (mirror/EyeSight)
    • High Beam Assist Current Setting

    Is [High Beam Assist Function Setting (mirror/EyeSight)] set to [EyeSight HBA], and [High Beam Assist Current Setting] set to [ON]?

    Yes  : Go to  2.

    No  : Set [High Beam Assist Function Setting (mirror/EyeSight)] to [EyeSight HBA], and set [High Beam Assist Current Setting] to [ON].

  2. CHECK DTC  .

    Using the Subaru Select Monitor, read all DTCs. Ref. to COMMON (diag)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Are any DTCs displayed? (Current malfunction)

    Yes  : Perform the diagnosis for the displayed DTCs. Ref. to BODY CONTROL (DIAGNOSTICS)>Diagnostic Trouble Code (DTC)>LIST .

    No  : Go to  3.

  3. CHECK "EyeSight TEMPORARY STOP INDICATOR"  .
    1. Turn the ignition switch to OFF.
    2. Turn the ignition switch to ON.
    3. Check "EyeSight temporary stop indicator". Ref. to EyeSight (DIAGNOSTICS)>EYESIGHT HALT CODE .

    Is "EyeSight temporary stop indicator" displayed?

    Yes  : Perform inspection according to "EyeSight temporary stop code" in "ES (DIAGNOSTICS)".

    No  : Go to  4.

  4. CHECK HIGH BEAM ASSIST INDICATOR  .
    1. Turn the ignition switch to ON.
    2. Set the light SW position to Auto.
    3. Set the dimmer Hi SW to ON.
    4. Shade the auto lighting sensor.

    Does the high beam assist indicator illuminate?

    Yes  : The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No  : Go to  5.

  5. CHECK HIGH BEAM ASSIST INDICATOR  .

    Using the Subaru Select Monitor, check the following items in the [Active Test] of [Combination Meter]. Ref. to COMBINATION METER (DIAGNOSTICS)>ACTIVE TEST .

    • HBA indicator

    Does the high beam assist indicator illuminate?

    Yes  : Replace the combination meter, m Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .

    No  : Replace the body integrated unit. Ref. to SECURITY AND LOCKS>BODY INTEGRATED UNIT .

scientia non olet · About LEMON Manuals