LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) (Service Information) >> Blower Motor Unit Assembly >> Removal

Blower Motor Unit Assembly: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Refer to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the glove box. Refer to EXTERIOR/INTERIOR TRIM>GLOVE BOX>REMOVAL .
  3. Remove the engine control module (ECM). (STI model) Refer to FUEL INJECTION (FUEL SYSTEMS) (STI)>ENGINE CONTROL MODULE (ECM)>REMOVAL .
  4. Remove the blower motor unit assembly.
    1. Release the claws, and then remove the grille assembly - ventilation RH.
    2. Disconnect the blower motor relay and each connector.
      G10270282Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the bolts and nuts to remove blower motor unit assembly.
      NOTE: Remove the RH upper nut from the mounting portion of the grille assembly ventilation RH.
      G08316131Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals