Intake Duct No. 1

Except for Canada

Install the intake duct No. 1 to the turbocharger.

NOTE:

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Install the air intake boot (A) to the intake duct No. 1, and engage the clip (B) which secures the air by-pass valve to the intake duct No. 1.

Tightening torque:

2.5 N.m (0.3 kgf-m, 1.8 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Connect the vacuum control hose to the wastegate control solenoid valve.

Courtesy of SUBARU OF AMERICA, INC.

Connect the PCV pipe assembly to the intake duct No. 1.

NOTE: Make sure that the blow-by diagnosis connector is connected securely.

Courtesy of SUBARU OF AMERICA, INC.

Connect the connector to the wastegate control solenoid valve.

Courtesy of SUBARU OF AMERICA, INC.

Connect the blow-by diagnosis connector (A) to the engine wiring harness, and connect the vacuum hose (B) to the vacuum pipe assembly.

Courtesy of SUBARU OF AMERICA, INC.

Install the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
Lower the vehicle.
Install the air intake duct. Refer to INTAKE (INDUCTION) (W/O STI)>AIR INTAKE DUCT>INSTALLATION .
Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .

For Canada

Install the intake duct No. 1 to the turbocharger.

NOTE:

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Engage the clip which secures the air by-pass valve to the intake duct No. 1.

Courtesy of SUBARU OF AMERICA, INC.

Connect the vacuum control hose (A) to the wastegate control solenoid valve, and install the air intake boot (B) to the intake duct No. 1.

Tightening torque:

2.5 N.m (0.3 kgf-m, 1.8 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Connect the PCV pipe assembly to the intake duct No. 1.

NOTE: Make sure that the blow-by diagnosis connector is connected securely.

Courtesy of SUBARU OF AMERICA, INC.

Connect the engine coolant hose to the intake duct No. 1.

Courtesy of SUBARU OF AMERICA, INC.

Connect the connector to the wastegate control solenoid valve.

Courtesy of SUBARU OF AMERICA, INC.

Connect the blow-by diagnosis connector (A) to the engine wiring harness, and connect the vacuum hose (B) to the vacuum pipe assembly.

Courtesy of SUBARU OF AMERICA, INC.

Install the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
Install the air intake duct. Refer to INTAKE (INDUCTION) (W/O STI)>AIR INTAKE DUCT>INSTALLATION .
Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .
Fill engine coolant. Refer to COOLING(W/O STI)>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT .