LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Intake System (Induction) And Turbocharger (2.0L) >> Air Intake Boot >> Removal

Air Intake Boot: Removal

  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the air cleaner case. Refer to INTAKE (INDUCTION) (W/O STI)>AIR CLEANER CASE>REMOVAL .
  3. Lift up the vehicle.
  4. Remove the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  5. Remove the air intake boot from the intake duct No. 1.
    G11266598Courtesy of SUBARU OF AMERICA, INC.
  6. Lower the vehicle.
  7. Remove the nuts which secure the turbo duct to the vehicle, and remove the air intake boot from the upper side of the vehicle together with the turbo duct.
    G10266536Courtesy of SUBARU OF AMERICA, INC.
  8. Lift up the vehicle.
  9. Remove the clips (A) which secure the front mud guard RH to the front bumper, and remove the screw which secures the front mud guard RH to the vehicle.
    G10266537Courtesy of SUBARU OF AMERICA, INC.
  10. Turn over the front mud guard RH and remove the duct bracket from the vehicle.
G10266538Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals