Brake Vacuum Pump: Installation
- Install the bracket - generator.
Tightening torque:
19 N.m (1.9 kgf-m, 14.0 ft-lb)
- Install the vacuum pump assembly.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Install the vacuum hose COMPL.NOTE: Install the clip to the position (arrowed) of alignment mark of intake manifold.
- Install the collector cover. Refer to INTAKE (INDUCTION) (W/O STI)>COLLECTOR COVER>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .