LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim & Interior Trim >> Glove Box >> Removal

Glove Box: Removal

NOTE: Refer to "Security and Locks" information for key cylinder replacement. Refer to SECURITY AND LOCKS>KEY LOCK CYLINDERS>REPLACEMENT>GLOVE BOX LID .
  1. Disconnect the ground cable from battery. Refer to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the pocket assembly.
    1. Attach the protective tape (a) to the panel center LWR.
    2. Remove the damper COMPL - pocket.
    3. Release the stoppers and remove the pocket assembly by pulling it toward you.
      G08316229Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the back panel - pocket.
    1. Remove the clips, and remove the cover - instrument panel side RH.
      NOTE: Remove the cover - instrument panel side RH by using a plastic remover.
    2. Release the clips, and remove the ornament - panel assembly passenger.
      G10271210Courtesy of SUBARU OF AMERICA, INC.
      NOTE: To facilitate the removal, push the clip of the ornament - panel assembly passenger from the backside.
    3. Remove the glove box light LED, and disconnect the connector.
    4. Remove the screws, claws and harness clamp, then remove the back panel - pocket.
      G08549811Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals