Related Lines, More Than 52 Ω And Less Than 62 Ω (Power Unit Can_VDC)

Wiring diagram: 

CAN communication system Ref. to WIRING SYSTEM>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS  .
   1. Disconnect the VDC control module connector.
   2. Using a tester, measure the resistance between terminals in VDC control module connector.

      Connector and terminal 

      (B66) No. 5 - (B66) No. 19:

      Is the resistance 400 Ω or more?

      Yes  : A related line between VDC control module and main wiring harness is open, or main wiring harness is open at two places or more.

      No  : Go to  2 .

2. CHECK RELATED LINES  .
   1. Disconnect the central gateway control module connector.
   2. Using a tester, measure the resistance between VDC control module connector and central gateway control module connector.

      Connector and terminal 

      (B66) No. 5 - (i88) No. 24:

      (B66) No. 19 - (i88) No. 23:

      Is the resistance 10 Ω or more?

      Yes  : Repair or replace the open circuit of VDC related lines.

      No  : Check DTC of VDC. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .