Vehicle Information (Driving Statistics, Advanced Package, Info Bar) Is Not Displayed, Or The Display Differs From The Actual Operation
Probable cause:
Communication error with the related systems
CAUTION:
Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to COCKPIT CONTROL (DIAGNOSTICS)>General Description>CAUTION .
- CHECK DTC
.
- Using the Subaru Select Monitor, perform the clear memory of [Cockpit Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Turn the ignition switch OFF → ON.
- Read the DTC of [Cockpit Control] using the Subaru Select Monitor. Ref. to Cockpit Control (Diagnostics)>Diagnostic Trouble Code (DTC) .
Is DTC of U*** displayed? (Current malfunction)
Yes: Perform the inspection according to the diagnosis for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
No: Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.