Related Lines, More Than 52 Ω And Less Than 62 Ω ((H) Advanced Safety Can_BSD/RCTA)

Wiring diagram: 

CAN communication system Ref. to WIRING SYSTEM>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS  .
   1. Disconnect the radar sensor LH connector.
   2. Using a tester, measure the resistance between terminals in radar sensor LH connector.

      Connector and terminal 

      (L107) No. 2 - (L107) No. 7:

      Is the resistance 400 Ω or more?

      Yes  : A related line between radar sensor LH and main wiring harness is open, or main wiring harness is open at two places or more.

      No  : Go to  2 .

2. CHECK RELATED LINES  .
   1. Disconnect the central gateway control module connector.
   2. Using a tester, measure the resistance between radar sensor LH connector and central gateway control module connector.

      Connector and terminal 

      (L107) No. 2 - (i88) No. 34:

      (L107) No. 7 - (i88) No. 33:

      Is the resistance 10 Ω or more?

      Yes  : Repair or replace the open circuit of the Blind Spot Detection/Rear Cross Traffic Alert related lines.

      No  : Check DTC of radar sensor. Ref. to BLIND SPOT DETECTION/REAR CROSS TRAFFIC ALERT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .