LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Legacy Base >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Front Wiper Arm >> Removal

Front Wiper Arm: Removal

CAUTION: When standing up the arm assembly windshield wiper, make sure to hold the arm portion. Holding the blade portion may cause the blade deformation.
G13952031Courtesy of SUBARU OF AMERICA, INC.
NOTE: When standing up the arm assembly windshield wiper, perform the driver's side first in order not to interfere the arms with each other.
  1. Remove the cover windshield wiper arm.
  2. Remove the arm assembly windshield wiper.
    1. Press the claw (a) and remove the cover joint from the cowl panel assembly.
      G13952032Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the hose wiper arm washer from the joint washer hose.
    3. Remove the nuts, and remove the arm assembly windshield wiper.
      G13952033Courtesy of SUBARU OF AMERICA, INC.
    4. Put alignment marks (a) at two places and disconnect the hose washer from the nozzle.
      CAUTION: Do not remove the wiper washer nozzle from the arm assembly windshield wiper.
      If nozzle replacement is required, replace the arm assembly windshield wiper assembly as a unit.
      G13952034Courtesy of SUBARU OF AMERICA, INC.
    5. Pull out the hose washer from the arm assembly windshield wiper assistor.
scientia non olet · About LEMON Manuals