LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Forester Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> SUBARU Eyesight System (Driver Assist) (Diagnostics) >> Diagnostics With Phenomenon >> Inspection >> Cruise Control Is Not Released After Brake Pedal Has Been Depressed

Cruise Control Is Not Released After Brake Pedal Has Been Depressed

  1. PERFORM REAL TIME DIAGNOSIS  .

    Check the input signal of cruise control system. Ref. to EYESIGHT (DIAGNOSTICS)>REAL-TIME DIAGNOSIS .

    Is the check result OK?

    Yes  : The circuit has returned to a normal condition at this time.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No  : Go to  2 .

  2. CHECK STOP LIGHT AND BRAKE SWITCH  .

    Check stop light switch and brake switch. Ref. to BRAKE>BRAKE PEDAL . Ref. to EYESIGHT (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH ECU CANCEL CODE>12 .

    Is the check result OK?

    Yes  : Replace the ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>ENGINE CONTROL MODULE (ECM) .

    No  : Repair or replace the faulty portion according to the inspection result.

scientia non olet · About LEMON Manuals