Cooling Blower
WARNING: This page is about a different variant/trim than selected.
WARNING:
The hybrid system includes a high voltage circuit. Mishandling could cause accidents such as electric shock or leak. Always check "WARNING (HYBRID SYSTEM)" and perform the proper operation. Ref. to PRECAUTION/WARNING>WARNING (HYBRID SYSTEM)
.
CAUTION:
Airbag system satellite safing sensor is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
- Install the charger cooling blower.WARNING:
- Be sure to wear insulated gloves.
- Be sure to use an insulating sheet at locations other than the work location.
Tightening torque: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the cover - charger.WARNING: Be sure to wear insulated gloves.
Tightening torque: 15 N.m (1.5 kgf-m, 11.1 ft-lb)
- Install the bar - floor front COMPL.
Tightening torque: 28 N.m (2.9 kgf-m, 20.7 ft-lb)
- Install the trim panel - rear apron. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>INSTALLATION .
- Install the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>INSTALLATION .
- Install the service disconnect plug. Ref. to HYBRID ELECTRIC VEHICLE>SERVICE PLUG>INSTALLATION .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .