LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Sport >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Hybrid Electric Vehicle System) >> Charge Inlet >> Inspection >> Charging Inlet Door >> Lid Switch

Lid Switch

WARNING: This page is about a different variant/trim than selected.
  1. Check the charging connector lock/unlock switch.
    1. Measure the resistance between connector terminals.

      Preparation tool:  Circuit tester

      G13939850Courtesy of SUBARU OF AMERICA, INC.
      Terminal No. Inspection conditions Standard
      2 - 4 When the lock/unlock switch is pressed Less than 50 Ω
      When the lock/unlock switch is not pressed 10 kΩ or more
    2. Replace the EV charger lid switch assembly if the inspection result is not within the standard value.
  2. Check illumination of the charging inlet light.
    1. Apply battery voltage between the connector terminals to check the lighting condition of the light.
      G13939851Courtesy of SUBARU OF AMERICA, INC.
      Terminal No. Inspection conditions Specification
      1 (+) - 4 (-) Apply battery voltage. Light ON
    2. Replace the EV charger lid switch assembly if the inspection result is not within the standard value.
scientia non olet · About LEMON Manuals