DTC P2457: EGR Cooler "A" Efficiency Below Threshold: Notes
- -
DTC detecting condition:
Immediately at fault recognition
Trouble symptom:
- Improper idling
- Poor driving performance
- CHECK DTC AND FREEZE FRAME DATA
.
- Turn the ignition switch to ON.
- Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC other than P2457 displayed? (Current malfunction)
Yes: Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO(HEV))>DIAGNOSTIC TROUBLE CODE (DTC) .
No: Go to 2.
- CHECK EGR COOLER WATER HOSE
.
Check the water hose connected to the EGR cooler. Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO(HEV))>EGR COOLER>INSPECTION .
Is the water hose bent?
Yes: After repairing extremely bent sections of the water hose, go to the next step. Go to 3.
No: Go to 4.
- CHECK NORMAL RECOVERY
.
Perform drive cycle AK. Ref. to ENGINE (DIAGNOSTICS) (H4DO(HEV))>INSPECTION MODE>PROCEDURE>INSPECTION MODE AK .
Is DTC P2457 displayed? (Current malfunction)
Yes: Go to 4.
No: Finish checking.
- CHECK EGR COOLER
.
Check the water hose and EGR system lines. Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO(HEV))>EGR COOLER>INSPECTION .
Is there any dirt, clogging or leak in the water hose or EGR system lines?
Yes: After confirming the following items, clean and securely install the parts.
- Remove dirt or clogging in the water hose.
- Remove dirt in the EGR cooler.
NOTE: Use parts cleaner for cleaning out dirt in EGR cooler. Perform air blow after cleaning .No: Replace the EGR cooler, EGR control valve or EGR pipe. Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO(HEV))>EGR COOLER . Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO(HEV))>EGR CONTROL VALVE . Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO(HEV))>EGR PIPE .