DTC P0125: Insufficient Coolant Temperature For Closed Loop Fuel Control: Notes

WARNING: This page is about a different variant/trim than selected.

1. -

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

Trouble symptom:

Engine does not return to idle

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO(HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK ENGINE COOLANT .
Check the following items:
- Amount of engine coolant
- Engine coolant freeze
- Contamination of engine coolant
Is the check result OK?

Yes: Go to 2.

No: Fill or replace the engine coolant. Ref. to COOLING (H4DO(HEV))>ENGINE COOLANT>REPLACEMENT .
CHECK THERMOSTAT .
Check the thermostat. Ref. to COOLING (H4DO(HEV))>THERMOSTAT>INSPECTION .

Does the thermostat remain opened?

Yes: Replace the thermostat. Ref. to COOLING (H4DO(HEV))>THERMOSTAT .

No: Replace the engine coolant temperature sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO(HEV))>ENGINE COOLANT TEMPERATURE SENSOR .