When "12V Battery Inspection Required" Is Displayed On The Meter

WARNING: This page is about a different variant/trim than selected.

CHARGE BATTERY .
Charge the battery. Ref. to STARTING/CHARGING SYSTEMS (H4DO(HEV))>BATTERY>CHARGE .

Is the battery charged?

Yes: Go to 2.

No:
1. Replace the battery with a new part. Ref. to STARTING/CHARGING SYSTEMS (H4DO(HEV))>BATTERY .
2. Go to 3.
CHECK BATTERY .
Check the battery. Ref. to STARTING/CHARGING SYSTEMS (H4DO(HEV))>BATTERY>INSPECTION .

Is the battery OK?

Yes: Go to 3.

No:
1. Replace the battery with a new part. Ref. to STARTING/CHARGING SYSTEMS (H4DO(HEV))>BATTERY .
2. Go to 3.
CHECK WIRING AND TERMINAL (BETWEEN BATTERY (12V) - HYBRID VEHICLE CONTROL ECU ASSEMBLY) .
Check the wiring and terminals.

Are the wiring and the contact of the terminal normal?

Yes: System is normal.

Restore the vehicle and repeat turning the ignition switch to OFF (for three seconds) ↔ ON (for three seconds) three times or more with all the electric load turned OFF. Then confirm that "12 V battery inspection required" is not displayed on the meter.

No:
1. Repair the defective part.
2. Repeat turning the ignition switch to OFF (for three seconds) ↔ ON (for three seconds) three times or more with all the electric load turned OFF. Then confirm that "12 V battery inspection required" is not displayed on the meter.