Inhibitor Switch Signal Circuit
WARNING: This page is about a different variant/trim than selected.
- Disconnect the ground terminal from battery. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
- Remove the clip from the air intake boot, and loosen the clamp.
- Remove the air intake boot, and place it aside so that it does not interfere with the work.CAUTION: Be careful not to pull out the PCV hose.
- Disconnect the inhibitor harness connector.
- Check the inhibitor switch signal circuit.
- Check the circuit of each range.
NOTE: If faulty, check the inhibitor harness for open circuit or short circuit, or poor contact.
| Terminal No. | Inspection conditions | Standard |
|---|---|---|
| 3 - 5 | P range | Less than 1 Ω |
| 3 - 6 | ||
| 3 - 11 | ||
| 3 - 1 | R range | |
| 3 - 6 | ||
| 3 - 11 | N range | |
| 3 - 19 | ||
| 3 - 15 | D range | |
| 3 - 18 | ||
| 3 - 11 | B range | |
| 3 - 15 | ||
| 3 - 18 |