Cruise Control Is Not Released After Shifting The Shifting Lever To The Neutral Position

WARNING: This page is about a different variant/trim than selected.

PERFORM REAL TIME DIAGNOSIS .
Check the input signal of cruise control system. Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>REAL-TIME DIAGNOSIS .

Is the check result OK?

Yes: The circuit has returned to a normal condition at this time.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

No: Go to 2.
CHECK NEUTRAL POSITION SWITCH .
Check the neutral position switch. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P0705-62: TRANSMISSION RANGE SENSOR "A" CIRCUIT (PRNDL INPUT) SIGNAL COMPARE FAILURE .

Is the check result OK?

Yes: Go to 3.

No: Repair or replace the faulty portion according to the inspection result.
CHECK STEREO CAMERA POWER SUPPLY VOLTAGE .
Check the stereo camera power supply voltage. Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B2814: POWER SUPPLY LOW VOLTAGE .

Is the check result OK?

Yes: Replace the stereo camera. Ref. to EYESIGHT>STEREO CAMERA>REMOVAL .

No: Repair or replace the faulty portion according to the inspection result.