DTC C1362: Normal Closing Valve 2

WARNING: This page is about a different variant/trim than selected.

DTC Detecting condition:

A fault is detected if electrical malfunction judgment is generated for VDCH/U solenoid valve.

Trouble symptom:

ABS does not operate.
EBD does not operate.
VDC does not operate.
Hill hold does not function.
EyeSight does not operate.

Wiring diagram:

Vehicle dynamics control system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>VEHICLE DYNAMICS CONTROL SYSTEM .

Courtesy of SUBARU OF AMERICA, INC.

CHECK VDCCM AND H/U INPUT VOLTAGE .
1. Turn the ignition switch to OFF.
2. Disconnect the connector from the VDCCM and H/U.
3. Run the engine at idle.
4. Measure the voltage between VDCCM and H/U connector and chassis ground.
  Connector and terminal
  
  (B310) No. 1 (+) - Chassis ground (-):
  
  (B310) No. 30 (+) - Chassis ground (-):
  
  (B310) No. 35 (+) - Chassis ground (-):
Is the voltage 10 - 15 V?

Yes: Go to 2.

No: Repair the power supply circuit including the battery.
CHECK VDCCM AND H/U GROUND CIRCUIT (CHECK FOR OPEN CIRCUIT) .
1. Turn the ignition switch to OFF.
2. Measure the resistance between VDCCM and H/U connector and chassis ground.
  Connector and terminal
  
  (B310) No. 14 - Chassis ground:
Is the resistance less than 10 Ω?

Yes: Go to 3.

No: Repair the VDCCM and H/U ground harness.
CHECK POOR CONTACT OF CONNECTORS .
Is there poor contact of connector between generator, battery and VDCCM and H/U?

Yes: Repair the connector.

No: Go to 4.
CHECK VDCCM AND H/U .
1. Connect all connectors.
2. Using the Subaru Select Monitor, perform the clear memory of [Brake Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
3. Execute the inspection mode. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>INSPECTION MODE .
4. Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is the same DTC displayed?

Yes: Replace the VDCCM and H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U) .

No: Go to 5.
CHECK DETECTION OF OTHER DTCS FOR VDC .
Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

Is any other DTC displayed?

Yes: Perform the diagnosis according to the DTC. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

No: Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.