Hybrid Powertrain Control Module: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- To avoid the damage to bracket and ECM, do not reuse the bracket.
- After installing the bracket to ECM, do not separate the bracket.
- If the bracket has been installed to ECM in the wrong way, replace both parts to new parts.
- Install the AWD control module onto the hybrid vehicle control ECU assembly.
Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb)
- Install the hybrid vehicle control ECU assembly together with the AWD control module.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .