Inspection Using Can Diagnostic

WARNING: This page is about a different variant/trim than selected.

Trouble causes:

Improper body integrated unit setting

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .

CHECK BODY INTEGRATED UNIT REGISTRATION STATUS .
Check that settings of body integrated unit correspond to vehicle equipment. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT .

Does the vehicle equipment correspond to settings?

Yes: Go to 2.

No: Match the settings of the body integrated unit with the vehicle equipment.
CHECK BODY INTEGRATED UNIT CUSTOMIZE SETTING .
Check that settings of body integrated unit correspond to vehicle condition. Ref. to BODY CONTROL (DIAGNOSTICS)>CUSTOMIZE .

Do the customize settings correspond to the vehicle condition?

Yes: Go to 3.

No: Match the settings of the body integrated unit with the vehicle condition.
CHECK FACTORY INITIAL SETTING OF BODY INTEGRATED UNIT .
Confirm [Factory initial setting] of body integrated unit registrations is [Market]. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT .

Is it set to [Market]?

Yes: Go to step 4 in the Basic Diagnostic Procedure. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

No: Switch from [Factory] to [Market].