DTC B2807: ECM Abnormal

WARNING: This page is about a different variant/trim than selected.

Detected when brake switch malfunction is detected by the engine control module (ECM).

Wiring diagram:

Stop light system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>STOP LIGHT SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .

CHECK STOP LIGHT AND BRAKE SWITCH .
Check the stop light and brake switch. Ref. to CRUISE CONTROL SYSTEM>STOP LIGHT AND BRAKE SWITCH .

Is the check result for the stop light and brake switch OK?

Yes: Go to 2.

No: Replace the stop light and brake switch. Or adjust the installation position.
CHECK STOP LIGHT AND BRAKE SWITCH CIRCUIT .
1. Turn the ignition switch to OFF.
2. Disconnect the stop light and brake switch connector.
3. Turn the ignition switch to ON.
4. Measure the voltage between connector terminal and chassis ground.
  Connector and terminal
  
  (B65) No. 1 (+) - Chassis ground (-):
Is the voltage 10 V or more?

Yes: Go to 3.

No:
- Check fuse No. 37 (fuse and relay box).
- Check for open or short circuit in harness between the stop light and brake switch and the fuse and relay box.
CHECK STOP LIGHT AND BRAKE SWITCH CIRCUIT .
Measure the voltage between connector terminal and chassis ground.

Connector and terminal

(B65) No. 5 (+) - Chassis ground (-):

Is the voltage 10 V or more?

Yes: Go to 4.

No:
- Check fuse No. 19 (fuse and relay box).
- Check for open or short circuit in harness between the stop light and brake switch and the fuse and relay box.
CHECK STOP LIGHT AND BRAKE SWITCH CIRCUIT .
1. Turn the ignition switch to OFF.
2. Disconnect the ECM connector.
3. Measure the resistance between ECM connector terminal and stop light and brake switch connector terminal.
  Connector and terminal
  
  (B65) No. 4 - (B134) No. 36:
  
  (B65) No. 2 - (B134) No. 38:
Is the resistance less than 10 Ω?

Yes: Go to 5.

No: Repair the harness.
CHECK STOP LIGHT AND BRAKE SWITCH CIRCUIT .
1. Connect the stop light and brake switch connector.
2. Turn the ignition switch to ON.
3. Measure the voltage between ECM connector and chassis ground both when the brake pedal is depressed and when not depressed.
  Connector and terminal
  
  (B134) No. 36 (+) - Chassis ground (-):
  
  (B134) No. 38 (+) - Chassis ground (-):
Does the voltage appear in (B134) No. 38 when the brake pedal is depressed? (0 V when the brake pedal is not depressed)

Does the voltage appear in (B134) No. 36 when the brake pedal is not depressed? (0 V when the brake pedal is depressed)

Yes: Replace the ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO(HEV))>ENGINE CONTROL MODULE (ECM) .

No: Replace the stop light and brake switch Ref. to CRUISE CONTROL SYSTEM>STOP LIGHT AND BRAKE SWITCH .