Stop Light Switch: Installation
CAUTION:
Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION
.
- Install the stop light switch onto the bracket with screws and position it with the nut.
- Adjust the stop light switch position, and then tighten the nut. Ref. to BRAKE>STOP LIGHT SWITCH>ADJUSTMENT>CLEARANCE ADJUSTMENT .
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
- Install the knee airbag module.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the cover assembly - instrument panel LWR driver.
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
NOTE:
For the hybrid model, connect the battery negative terminal.