DTC B2247: Cd Mechanical
DTC detecting condition:
- If EJECT error is detected
- If over-current is detected
- If DSP error is detected
- If playback failure is detected
Trouble symptom:
- CD and DVD cannot be played back.
- Cannot be inserted or ejected.
CAUTION:
Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to INFOTAINMENT (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .
- CHECK MEDIA
.
- Check for dirt on the disc surface of the media, and clean the disc softly using soft and dry cloth such as a plastic eyeglasses cleaning cloth. When cleaning, make sure that wiping direction is from the center to the edge of the disc.CAUTION: To avoid any scratch on the surface, do not apply excessive force with hand or do not use a rough cloth. Do not use solvent such as alcohol, benzene, thinner, etc. as well as chemical cloth to avoid damaging the disc.
- Insert the media and make sure that it can be played back.
Is the check result OK?
Yes: There were some problems with the media.
No: Go to 2.
- Check for dirt on the disc surface of the media, and clean the disc softly using soft and dry cloth such as a plastic eyeglasses cleaning cloth. When cleaning, make sure that wiping direction is from the center to the edge of the disc.
- CHECK MEDIA
.
Insert another media which is properly functioning.
NOTE: Supported media type: Audio CD, CD-R, CD-RWIs the check result OK?
Yes: There were some problems with the media.
No: Replace the audio or navigation unit. Ref. to ENTERTAINMENT & MONITORING>AUDIO . Ref. to ENTERTAINMENT & MONITORING>NAVIGATION BODY .