Hybrid Model

NOTE:

Before installation, remove mud and foreign matter from the disc brake assembly.
Check that the battery ground terminal is disconnected.

Install the pad - disc brake rear.
Install the caliper body assembly.
CAUTION: Securely install the electronic parking brake harness connector.

Tightening torque:

Guide pin - rear brake: 25 N.m (2.5 kgf-m, 18.4 ft-lb)

Brake hose bracket: 33 N.m (3.4 kgf-m, 24.3 ft-lb)
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
Using the Subaru Select Monitor, exit the brake maintenance mode according to the display screen. Ref. to PARKING BRAKE>PARKING BRAKE SYSTEM>OPERATION>BRAKE MAINTENANCE MODE .
After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally.
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)