Front Brake Hose
- Secure the brake hose to the brake hose mount part of strut COMPL.
Tightening torque:
Brake hose: 33 N.m (3.4 kgf-m, 24.3 ft-lb)
- Connect the brake hose to the caliper body assembly using a new gasket.
Tightening torque:
Union bolt: 26 N.m (2.7 kgf-m, 19.2 ft-lb)
- Position the disc in straight position and route the brake hose through the hole in the bracket on the wheel apron side.CAUTION: Do not twist the brake hose.
- Connect the brake pipe and the hose, then temporarily tighten the flare nut.
- Secure the brake hose to wheel apron bracket with clamp.
- Turn and tighten the flare nut (b) by hand while pushing the brake pipe (a) away from yourself.CAUTION: Be careful not to make scratches or other damage to the inside surface of the brake pipe flare.
Tightening torque:
Brake pipe flare nut: 15 N.m (1.5 kgf-m, 11.1 ft-lb)
- Bleed air from the brake line.
- Except for hybrid model: Ref. to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE (EXCEPT FOR HYBRID MODEL) .
- Hybrid model: Ref. to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE (HYBRID MODEL) .
- Install the front wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)