Check Stroke Simulator
- Check that the voltage of the 12 volt auxiliary battery is correct.
- Connect a measuring device as shown in the figure.
- Using the Subaru Select Monitor, perform the clear memory. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Using the Subaru Select Monitor, read [Stroke Sensor 1 Revision Voltage] and [Stroke Sensor 2 Revision Voltage] on the [Data Monitor] display.
- Depress the brake pedal 4 - 5 times.
- Check each stroke sensor output value when the brake pedal is depressed.
Specification:
| Brake pedal force: N (kgf, lbf) | 50 (5.1, 11.2) | 100 (10.2, 22.5) | 150 (15.3, 33.7) |
| Stroke sensor 1 correction voltage: V | 1.09 - 1.79 | 1.23 - 1.93 | 1.32 - 2.02 |
| Stroke sensor 2 correction voltage: V | 3.21 - 3.91 | 3.07 - 3.77 | 2.98 - 3.68 |